JUKI HZL-X Series User Manual

– 33 –
6-20-3 Adjusting the height of the presser foot when it is lifted
* Be sure to carry out the following adjustment every time you have adjusted the knee-lifter wire, auto-lifter
cam lever or presser-lifter position sensor.
6-20-3-1 Adjusting the presser foot height to 0 (zero) mm
Adjustmentprocedure
 1.Select"No.21:0MMSETTING"oftheservicemode.
  Atthistime,checktobesurethatthefeeddogdoesnotappearabovethetopsurfaceofthroatplate.
 2.When"No.21:0MMSETTING"isselected,thepresserfootgoesupbyapproximately0.5mm.
  Ifnot,turnthestitchlengthadjustingdialinthe"+"directioninthecaseoftheDX7model,orpressthe
stitchlengthadjustingbuttoninthecaseoftheDX5modeltoliftthepresserfootbyapproximately0.5mm.
 3.Placeablockorthelikethicknessofwhichis6mmunderthepresserfoot.Operatethesewingmachine
inincrementsof1pulseinthe"-"directiontolowerthepresserfootuntilitsverticalplayiseliminated.
* Be sure to adjust the presser foot height by lowering it from its upper position. If you excessively
lower the presser foot, lift the presser foot again by approximately 0.5 mm.
 4.Pressthe"OK"button.
20 : MODEL SELECT
21 : 0MM SETTING
22 : 6MM SETTING
23 : – – – – – –
(551)
HZL-DX5
⇦
⇦
0.5 mm
20 : MODEL SELECT
21 : 0MM SETTING
22 : 6MM SETTING
23 : – – – – – –
(593)
20 : MODEL SELECT
21 : 0MM SETTING
22 : 6MM SETTING
23 : – – – – – –
(593)
The presser foot has
no vertical play.

JUKI HZL-X Series Specifications

General

Brand	JUKI
Model	HZL-X Series
Category	Sewing Machine
Language	English