－
15
－
4-3. Threading the machine head
Pull out the thread by approximately 40 mm from the needle after threading through the needle.
Loosen setscrew
❶
and hold needle
❷
with the
long groove
❸
facing toward you. Then fully insert
it into the hole in the needle bar, and tighten set-
screw
❶
.
4-2. Attaching the needle
If the stitches are made as shown in
A
,
attach the needle facing to the direc-
tion
B
to a small extent.
When threading the needle, carry out the following steps of procedure to lower the intermediate presser
and the feeding frame in prior.
(* Only for the LK-1920)
1) Press READY key
❶
on the operation panel.
2) Press PRESSER and WINDER key
❷
to lower the intermediate presser and the feeding frame.
3) After the completion of needle threading, press PRESSER and WINDER key
❷
again to return the
intermediate presser and the feeding frame to their upper position.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
WARNING :
Placing your hands or ngers under the presser foot may invite the risk of injury due to pinching by
the presser foot or puncture by the needle. Do not place your hands, etc. under the presser foot to
protect from injury.
❸
A
B
❶
❷
LK-1910S∆
LK-1920S∆
LK-1910H∆
LK-1920H∆
❶ ❷
To Next Page
Loading...
Need help?
General
