－
32
－
This sewing machine can perform sewing of plural sewing pattern data in one cycle in the order of the
data.
As many as 99 patterns can be input. Use this function for sewing two or more different patterns on the
sewing product. In addition, registration of as many as 99 cycles can be performed. Copy and use the
data to ll the needs.
→ Refer to
"6-5. Copying or deleting various kinds of pattern data" p.39
.
(1) Selection of cycle data
❻
6-2. Sewing using the combination function (cycle sewing)
1) Set the mode to the input mode
Under the input mode where SET READY
LED
goes out, selection of the cycle data
is enabled.
If the current mode is the sewing mode, press
READY key
❷
to change over the
mode to the input mode.
Only under the input mode, selection of the
cycle data is enabled.
2) Select cycle stitching data
Press ITEM SELECT key
❻
, and
patterns which have been registered are
changed over and displayed in order. Cycle
data No. and continuous stitching data No.
which have been registered after the last
registered pattern No. are displayed. Here,
select the cycle data No. which you desire to
sew.
3) Perform sewing
When READY key
❷
is pressed in
the state where the cycle data is selected,
SET READY LED
lights up to show that
the sewing is enabled.
Cycle data No. 1 only has been registered at
the time of your purchase. However, sewing
status cannot be obtained since the sewing
pattern has not been inputted. Perform input-
ting of sewing pattern referring to
(2) Method
of editing cycle data
on the next page.
❷
To Next Page
Loading...
Need help?
General
