－
39
－
6-5. Copying or deleting various kinds of pattern data
Data of pattern No. which has been already registered can be copied to pattern No. which has not been
used. Overwriting copy of the pattern is prohibited. When you desire to overwrite, perform it after eras-
ing the pattern once.
The patterns that can be copied are the following three types.
1.
Copying the standard pattern, user pattern and old user pattern to the user pattern
2. To copy the direct pattern
3. To copy the cycle pattern
❹❷
❻
❼
1) Set the mode to input mode
Under the input mode where SET READY
LED
goes out, copy is enabled. If the cur-
rent mode is the sewing mode, press READY
key
❷
to change over the mode to the
input mode.
2) Displaying the mode screen
Press MODE key
❹
to display the
mode screen. Put the pattern copy in the se-
lected state with ITEM SELECT key
❻
.
Then, press EDIT key
❽
.
3) Select pattern No. of copy source
Press ITEM SELECT key
❻
to select
the source pattern number for copying.
Types of patterns that can be selected are
standard patterns, user patterns and old user
patterns. Only the pattern numbers which
have been registered are displayed.
When you press RETURN key
❾
, the
copy function is cancelled and the screen
returns to the mode screen.
❻
❽
❷
❾
4) Select pattern No. of copy destination
Press DATA CHANGE key
❼
to select the pattern number to be copied.
5) Start copying
When READY key
❷
is pressed, the copy starts. Then, the screen returns to the input
screen on which the pattern No. which is created by copying is selected.
To Next Page
Loading...
Need help?
General
