－
40
－
6) Erasing the pattern
In the case of erasing the pattern, select ITEM SELECT key
❻
to select the pattern number
you want to delete. Press DATA CHANGE key
❼
to select Trash . Then, press READY
key
❷
. The delete conrmation screen is displayed. The pattern is deleted by pressing RE-
SET key
❸
on this screen.
* The standard pattern cannot be deleted.
* In the case of copying the direct pattern, select "06 Direct pattern copy" on the mode screen. In
the case of copying the cycle pattern, select "07 Cycle pattern copy" on the mode screen. Both the
direct pattern and the cycle pattern can be copied in the similar procedure.
❻
❻
❸❷
❼
* The pattern key and the cycle pattern can be
copied in the similar procedure. To create a
new cycle pattern, press ITEM SELECT key
❻
to select new creation
.
* To select a copied user pattern, press ITEM
SELECT key
❻
to display when
the pattern number is displayed on the upper
left section of the screen. Then, press DATA
CHANGE key
❼
to select a pattern
number.
To Next Page
Loading...
Need help?
General
