To Next Page

To Previous Page

JUNOSe 7.2.x Policy Management Configuration Guide

98 ! Two-Rate Rate-Limits

! mark—For IP and IPv6 rate-limit profiles, mark the packet by setting the

ToS byte (IP) or traffic class field (IPv6) to the specified 8-bit value, and

transmit the packet. The mark value is masked with the default 255 unless

it is overridden by the mask-val command to specify a different mask; not

supported on hierarchical rate limits.

! mark-exp—For MPLS rate-limit profiles, set the EXP bits of MPLS packets

to the specified value in the range 0–7, and transmit the packet. The mark

EXP value is masked with the default 7 unless you use the exp-mask

command to specify a different mask; not supported on hierarchical rate

limits.

! Packets are colored red.

! Example

host1(config-rate-limit-profile)#exceeded-action drop

! Use the no version to restore the default value, drop.

excess-burst

! For one-rate rate-limit profiles only, use to set the excess burst in bytes for a

rate-limit profile.

! Example

host1(config-rate-limit-profile)#excess-burst 3000000

! Use the no version to restore the default value, 0.

exp-mask

! Use to set the mask value used for MPLS rate-limit profiles; range is 1–255.

! This command is associated with the following commands:

! committed-action

! conformed-action

! exceeded-action

! Example

host1(config-rate-limit-profile)#exp-mask 5

! Use the no version to restore the default value, 7.

mask-val

! Use to set the mask value used for IP and IPv6 rate-limit profiles; range is

1–255.

! This command is associated with the following commands:

! committed-action

! conformed-action

! exceeded-action

Juniper E Series Configuration Guide

Other manuals for Juniper E Series