Juniper E Series Configuration Guide

JUNOSe 7.2.x Policy Management Configuration Guide
24 ! Creating Policy Lists
Creating a Policy List for IPv6
The following example creates an IPv6 policy list named routeForIPv6. For
information about creating the CLACL used in this example, see the previous
sections.
1. Create the policy list routeForIPv6.
host1(config)#ipv6 policy-list routeForIPv6
host1(config-policy-list)#
2. Create the classification group for the CLACL named ipv6tc67 and assign the
precedence to the classification group.
host1(config-policy-list)#classifier-group ipv6tc67 precedence 75
host1(config-policy-list-classifier-group)#
3. Add a rule to color packets as red, and a second rule that sets the traffic class
field of the packets to 7.
host1(config-policy-list-classifier-group)#color red
host1(config-policy-list-classifier-group)#mark tcfield 7
4. Exit Policy List Configuration mode to save the configuration.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#
5. Display the policy list.
host1#show policy-list routeForIPv6
Policy Table
------ -----
IPv6 Policy routeForIPv6
Administrative state: enable
Reference count: 0
Classifier control list: ipv6tc67, precedence 75
color red
mark tc-precedence 7
Creating a Policy List for Frame Relay
The following example creates a Frame Relay policy that on egress marks the DE bit
to 1, and on ingress colors frames with a DE bit of 1 as red.
1. Create the policy list used to mark egress traffic, then create the classifier group
for packets conforming to CLACL frMatchDeSet. Add a rule that marks the DE
bit as 1.
host1(config)#frame-relay policy-list frOutputPolicy
host1(config-policy-list)#classifier-group frMatchDeSet
NOTE: Commands that you issue in Policy Configuration mode do not take effect
until you exit from that mode.

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English