To Next Page

To Previous Page

JUNOSe 7.2.x Policy Management Configuration Guide

38 ! Creating Classifier Groups and Policy Rules

! rate-limit-profile—Rate limit is applied and the exception rule is applied to

packets.

! traffic-class—Traffic class is set and the exception rule is applied to

packets.

! user-packet-class—User packet class is set and the exception rule is

applied to packets.

! exception—Exception rule is applied to packets.

! Example

host1(config-policy-list-classifier-group)#exception http-redirect

! Use the no version to remove the exception rule from the classifier group.

filter

! Use to define a rule that drops all packets matching the current CLACL.

! You can enter the filter command while the policy list is referenced by

interfaces.

! Example

host1(config-policy-list-classifier-group)#filter

! Use the suspend version to suspend a filter rule within the classifier group.

! Use the no version to remove the filter rule from the classifier group.

forward

forward interface

forward next-hop

! Use to define a rule that creates the forwarding solution for packets matching

the current CLACL.

! The forward command can be used while the policy list is referenced by

interfaces.

! Example

host1(config-policy-list-classifier-group)#forward

! Use the suspend version to suspend the forward rule within the classifier group.

Juniper E Series Configuration Guide

Other manuals for Juniper E Series