Juniper JUNOS OS 10.4 User Manual

}
}
}
Router CE2
Configuration
Configure the dual-tagged Ethernet interface.
[edit]
interfaces {
ge-0/0/0 {
flexible-vlan-tagging;
encapsulation flexible-ethernet-services;
unit 0 {
vlan-tags outer 100 inner 34;
family inet {
address
30.1.1.10/24;
}
}
}
}
You verify your configuration on the MX Series router with the show l2circuit connections
command:
user@PE2>show l2circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid NP -- interface h/w not present
MM -- mtu mismatch Dn -- down
EM -- encapsulation mismatch VC-Dn -- Virtual circuit Down
CM -- control-word mismatch Up -- operational
VM -- vlan id mismatch CF -- Call admission control failure
OL -- no outgoing label IB -- TDM incompatible bitrate
NC -- intf encaps not CCC/TCC TM -- TDM misconfiguration
BK -- Backup Connection ST -- Standby Connection
CB -- rcvd cell-bundle size bad XX -- unknown
SP -- Static Pseudowire
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 10.255.171.45
Interface Type St Time last up # Up trans
ae0.0(vc 100) rmt Up May 12 14:48:58 2009 2
Remote PE: 10.255.171.45, Negotiated control-word: Yes (Null)
Incoming label: 299872, Outgoing label: 299824
Local interface: ae0.0, Status: Up, Encapsulation:VLAN Q-in-Q and VCI
Interworking
Configuring Router PE2 with a Remote Interface Switch
Router CE1
Configuration
The configuration of the remote interface switch is based on RSVP-signaled MPLS
connections.
Configure Ethernet over ATM on the ATM interface.
[edit]
interfaces {
85Copyright © 2012, Juniper Networks, Inc.
Chapter 8: MX Series Router in an ATM Ethernet Interworking Function

Juniper JUNOS OS 10.4 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.4
Category	Network Router
Language	English