Jura IMPRESSA Z7 User Manual

2 Preparation
18
E There is a short interval while the hot milk separates from the
milk foam. This allows the typical layers of a latte macchiato
to form. You can choose the length of this interval in program-
ming mode (see Chapter 4 ‘Permanent settings in program-
ming mode – Products’).
1 LATTE MAC. / COFFEE, coffee preparation starts.
The preset amount of water flows into the cup. Preparation
stops automatically and
ENJOY appears briefly on the dis-
play. Then
COFFEE READY is displayed.
To make sure the cappuccino frother always works properly, rinse
and clean it regularly (see Chapter 5 ‘Maintenance – Rinsing the
cappuccino frother’).
Example: Proceed as follows to prepare milk foam.
T Attach the milk pipe to the cappuccino frother. Use the long
pipe for a milk carton and the short pipe for the milk con-
tainer.
T Insert the other end of the milk pipe into a milk carton/bot-
tle or connect it to the milk container.
T Place a cup under the cappuccino frother.
T Turn the setting wheel of the cappuccino frother to the Milk
Foam 5 position.
E If you want to heat the milk turn the setting wheel of the cap-
puccino frother to the Milk z position.
z T Press the Milk button.
1MILK, the milk foam is prepared. Preparation stops auto-
matically and
COFFEE READY appears on the display.
To make sure the cappuccino frother always works properly, rinse
and clean it regularly (see Chapter 5 ‘Maintenance – Rinsing the
cappuccino frother’).
Warm milk and milk
foam

Jura IMPRESSA Z7 Specifications

General

Type	Coffee
Dimensions (WxDxH)	31 x 370 x 435 mm
Product type	Espresso machine
Built-in grinder	Yes
Capacity in cups	20 cups
Coffee input type	Coffee beans, Ground coffee
Coffee maker type	Fully-auto
Appliance placement	Countertop
Water tank capacity	2.8 L
Maximum operating pressure	15 bar
Lid type	Hinged lid
Color name	Alu
Cord length	1.1 m
Product color	Aluminum
Multi beverage	No

Weight and Dimensions

Weight	13500 g