JVC DR-MV1 User Manual

Filename [DR-MV1SE_04Name.fm]
Masterpage:Left+
18 EN
Page 18 March 11, 2004 7:27 pm
INITIAL SETTINGS
Auto Channel Set by Downloading from TV/Auto Clock
Set/Auto Guide Program Number Set
If you have connected the unit to your TV via a 21-pin SCART
cable (墌 pg. 16), the unit will automatically perform Preset
Download instead of the Auto Set Up in step 4 on page 17. After
downloading, the unit sets the clock and Guide Program numbers
automatically.
1 Press rt to select “T-V LINK”
and press ENTER. The T-V LINK
screen will appear.
A
TTENTION:
Preset positions on the front display
panel increase from “PR 1”; do NOT
press any button on the unit or
remote control until the front display
panel shows clock time, “PR 1” or
“– –:– –” as illustrated on page 19.
● When Preset Download is
completed, “COMPLETED”
appears for about 5 seconds, then
the normal screen appears.
● If you press any button on the unit
or remote control while
downloading is in progress, it will
be interrupted.
NOTES:
● For details, refer to the instruction manual of your TV.
● In the area where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto Clock Set
nor Auto Guide Program Number Set.
● If there is a power cut, or if you press 1 or SET UP while
downloading or set up is in progress, it will be interrupted; be sure to
turn off the unit power once and try again from the beginning.
● Auto Clock Set may not function properly depending on the reception
condition.
● On this unit, the characters available for station names (ID) are A–Z,
0–9, –,
f, + and I (space). Some names of downloaded stations
may differ from those of your TV. (
墌 pg. 84)
Preset Download
A
TTENTION:
You can use this function only with a TV offering T-V Link, etc.* Be
sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may differ by
system.
1
4
7
2
5
8
0
3
6
9
DISPLAY
8
DISPLAY
8
VCR/DVD
SAT
● Slide the TV/CABLE/SAT/DVD switch to DVD.
● Perform steps 1 to 3 of “Auto Set Up” (
墌 pg. 17) before continuing.
After “Preset Download” is completed, perform “Monitor Set
(DVD Deck Only)” on page 23.
DR-MV1SE_00.book Page 18 Thursday, March 11, 2004 7:28 PM

JVC DR-MV1 Specifications

General

Brand	JVC
Model	DR-MV1
Category	DVD VCR Combo
Language	English