Masterpage:Right+
EN 21
Filename [DR-MV1SE_04Name.fm]
Page 21 March 11, 2004 7:27 pm
INITIAL SETTINGS
The following procedure is required if you receive satellite channels
through a satellite receiver. Approximately 20 seconds before the
S
HOWVIEW timer programming (墌 pg. 43) or Manual Timer
programming (墌 pg. 44) starts, the unit sets its input mode to “L-2”
and automatically switches the satellite receiver’s channels using a
provided Satellite Controller.
Installing Satellite Controller
1 Place a Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
2 Fix securely using the adhesive strip attached on the back of the
Satellite Controller.
3 Be sure to connect the unit’s L-2 IN/DECODER connector to the
satellite receiver’s 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4 Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Setting Satellite Receiver’s Brand And Channel
After installation, set the satellite receiver’s brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
1 Turn on the satellite receiver’s power.
2 Press SET UP to access the Main Menu screen.
3 Press we to select “INITIAL SET UP”, then press ENTER.
4 Press we to select “SAT/
GUIDE PR”, then press ENTER.
5 Press rt to select “SAT
BRAND”, then press ENTER.
6 Press rt to select the brand
code from the list on page 22,
then press ENTER.
● If the brand code you entered is
invalid, the code field will be reset.
Enter the correct brand code again.
● If the unit is in playback or recording mode, you cannot set the brand
code.
7 Press the appropriate number
keys to enter one of the channel
positions on the satellite receiver,
then press ENTER twice. The unit
enters the Test mode.
● You can select the channel
position between 1 to 999.
Satellite Receiver Control Setting
L-1
L-2
IN/OUT
IN/DECODER
ANTENNA
IN
OUT
DVD/VCR
AUDIO OUT
LEFT
RIGHT
DIGITAL
AUDIO OUT
PCM/
STREAM
COAXIAL OPTICAL
DVD
DVD
SAT CONTROL
COMPONENT
VIDEO OUT
PB
PR
Y
2
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Tran smi tt er
21-pin SCART cable
(provided)
SAT CONTROL L-2 IN/DECODER
Your unit
Satellite Controller
(provided)
Satellite receiver
Back of unit
1
4
7
2
5
8
0
3
6
9
DISPLAY
8
DISPLAY
8
VCR/DVD
SAT
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
DR-MV1SE_00.book Page 21 Thursday, March 11, 2004 7:28 PM
To Next Page
Loading...
Need help?
General
