ENGLISH
11OPERATIONS
1 Move to the next (or previous) number
position.
2 Select a number.
3 Repeat steps 1 and 2 until you finish
entering a PIN code.
4 Confirm the entry.
5 Operate the target Bluetooth device, (while
“WAIT PAIR” is flashing on the display).
On the device to be connected, enter the same PIN
code you have just entered for this unit.
“PAIRING” flashes, then “PAIRING OK” appears on
the display when the connection is established.
Now you can use the device through the unit.
The device remains registered even after you
disconnect the device. Use “CNNCT PHONE” or
“CNNCT AUDIO” (or activate “AUTO CNNCT”) to
connect the same device from next time on. (See
the following and page 26.)
Deleting a registered device
Perform steps 1 and 2 on page 10, then...
1 Select “DELETE PAIR.”
2 Select a device you want to delete, then
select “YES.”
Connecting a registered device (PHONE/
AUDIO)
Perform steps 1 and 2 on page 10, then...
1 Select “CNNCT PHONE” or “CNNCT AUDIO.”
2 Select a device you want.
“CONNECTING” flashes, then “CONNECTED” appears
on the display when the device is connected.
You can set the unit to connect the Bluetooth device
automatically when the unit is turned on. (See
“AUTO CNNCT” on page 26.)
Disconnecting a device (PHONE/AUDIO)
Perform steps 1 and 2 on page 10, then...
Select “DISCN PHONE” or “DISCN AUDIO.”
“DISCONNECT” appears on the display.
EN08-15_KD-BT11[J]4.indd 11EN08-15_KD-BT11[J]4.indd 11 11/27/07 3:35:14 PM11/27/07 3:35:14 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
