51
Connecting a USB Storage Device
1. Switch off the TV before connecting any USB storage device.
2. Connect the supplied USB extension cable and your USB
storage device to the USB port of your TV.
3. Plug the connected devices into the mains socket before
switching on the TV.
4. Press the center of joystick function button under the TV
frame or the
button on the remote control to turn on your
TV and your USB storage device.
5. Press the INPUT button on the remote control to display
the Input Source menu. Use the
buttons on the remote
control to select USB and then press the OK button to
confirm.
• If a hard disk is used, make sure its mains adapter is connected to the mains supply.
• If a USB hub is used, make sure its mains adapter is connected to the mains supply as the total current consumption may
exceed 500mA.
• The maximum supported storage space of the hard disk is 1 TB.
• The file system only supports FAT32 format.
• If you want to store the video streaming of a DTV programme, the transfer rate of the USB storage device must not be less
than 5MB/s, otherwise the picture and sound of the programme will be affected and a warning statement will be shown
on the screen. If this happens, please upgrade your USB storage device.
• The TV screen will be blank temporarily as it will take time to start up and stabilise the connected hard disk. This is normal
and the starting time may vary depending on the brand and the memory size of the connected hard disk.
• Disconnect the USB storage device if it is not in use.
• Supports USB2.0 only.
7 Entertainment
Chapter
7
Rear Side View of TV
LAN RF
COMMON INTERFACE (CI)
HEADPHONES
USB
5V 500mA
Digital Output
HDMI2
USB Cable
(not included)
USB
Storage
Device
Adapter
Portable
hard Disk
USB Hub
Viewing Video
1. Press the INPUT button then press the buttons to select the USB
mode and then press the OK button.
2. Press the
buttons to select Video and then press the OK button.
2 3 41
Music PhotoVideo
Some video file formats will not be supported.
To Next Page
Loading...
General