2
8
Preparation
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV
slightly overhangs on it. Please make sure a soft cushioned material (such as a towel or thick piece of foam) is placed beneath
the screen. Leave the protective bag on your TV until you have fully attached the TV stand.
Installing the Base Stand
Attach the TV stand to the TV. Align the screw holes, then secure with a screw driver (not included) using the 4 screws provided.
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance:
For UK, please call our UK Call Centre on 0344 561 1234.
For Ireland, please call our Ireland Call Center on 1 890 818 575.
1. To remove the stand assembly, untighten the screws holding the stand assembly at the bottom of the TV. Remove the stand
assembly.
• Remove the stand assembly before mounting the TV onto the wall.
• If you are wall mounting your TV you may wish to buy a 90° HDMI adapter. This will help with your cable management.
Keep all the spare screws
should you want to use the
stand assembly option.
Mounting the TV to a Wall
TV Stand Base Front
(included)
To Next Page
Loading...
General