1. Description of the unit
1.1 Application
KEB COMBICONTROL C5 is a programmable control with direct connection upto four KEB
frequency inverters/servo axes of the series F5. The connection to the axes is created as
HSP5/485. All axes can be operated directly and synchronously with an inexpensive operator
with this fast, reliable connection. Cycle times down to one millisecond are realizable. This
manual describes the release of the rmware V1.4 and higher.
The axis control is programmed with the uniform IEC 61131-3 programming system CoDeSys
of the 3S-Software Company, Kempten (Germany) (www.3s-software.com).
1.2 Construction
The control consists of following modules:
• CPU and memory
• internal ash le system
• Switching power supply
• Real-time clock
• HSP5/485-interfaces to the inverter/servo axes
• Ethernet interfaces
• serial interface
• Control and error LED’s
• RUN/Reset switch
• Voltage supply connection
• four digital inputs
• four digital outputs
• Field bus interface (optional)
1.3 CE-certications
This unit was tested in accordance with the generic standard EN 61000-6-2 in the range of noise
immunity and corresponds to the EMC directive 89/336/EWG with changes/extensions.
1.4 Unitidentication
C5 Material number Description
Compact 14C5B00-1000 4DI/4DO
To Next Page
Loading...
Need help?
General
