CP 503/A, CP 505/A,D,K, CP 507/
A,C
Introduction
Project engineering manual V1.06
10
© KEBA 2021
Target group Knowledge and skills pre-requirement
Service technician
Basic technical training (Vocational high school, engineering degree
or corresponding professional experience).
Knowledge in:
● working mode of a PLC,
● current valid safety regulations,
● working mode of machine or plant,
● diagnosis possibilities,
● systematic error analysis and rectification.
1.3 Intended use
The CP 50x/x was developed for control applications in industrial machines.
The typical applications areas include injection molding machines, robots,
presses, machine tools and similar.
The CP 50x/x may only be used for the types of use detailed in the technical
description and only in compliance with the described technical framework
conditions. The CP 50x/x may only be used in connection with recom-
mended or approved devices.
The CP 50x/x has been developed, manufactured, tested and documented
observing the relevant instructions and standards. Therefore, provided that
the instructions and safety precautions are properly observed, the product
does not pose any danger to the health of persons or a risk of damage to
other property or equipment under normal circumstances.
1.4 Notes on this document
This manual is part of the product. It is to be retained over the entire life cy-
cle of the product and should be forwarded to any subsequent owners or
users of the product. The machine manufacturer or system supplier must in-
corporate the safety instructions and information required for end customers
into the operating instructions for end customers in the applicable national
language.
This documentation must be legible and available to the specified personnel
and must be read and understood by them.
1.4.1 Contents of the document
● Description of the module
● Mounting and installation instructions
● Description of interfaces
● Configuration
● Operating behavior
● Diagnostics functions
To Next Page
Loading...
Need help?
General
