CP 503/A, CP 505/A,D,K, CP 507/
A,C
Safety notes
Project engineering manual V1.06
13
© KEBA 2021
2.2 General safety instructions
WARNING!
● It is absolutely essential that you also observe the safety instructions in
the system manual for your automation system.
● The following application areas are expressly excluded for the CP 50x/x
without completing a special evaluation relating to the application and
implementing the necessary measures in the installation relating to the
operating conditions:
● Use in areas where there is a risk of explosion or fire
● Use in the mining sector
● Use in the open air
● Use in wet rooms or rooms with the risk of splashing water
● Use in environments with heavily polluted air
● Use in environments with harmful solutions, steams or radiations
● Use in non-stationary applications
● The CP 50x/x is not designed for safety-relevant control tasks (e.g.:
shutdown in case of an emergency). For safety-relevant control tasks
and personnel security, additional external safety measures must be im-
plemented to ensure the system remains in a safe operating condition
even in the event of a fault.
● At the developement of the CP 50x/x the standard EN ISO 13849-1 was
not considered.
● The module is defined as "open type equipment" (UL 61010-2-201) or as
"open equipment" (EN 61010-2-201) and must therefore be installed in a
control cabinet.
Caution
Improper use of the assembly or the control system leads to irrepara-
ble damage!
Turn off the power supply before inserting or removing the module. Other-
wise, the module can be destroyed or undefined signal states can lead to
damage of the control system.
To Next Page
Loading...
Need help?
General
