Keebox W150NR User Guide

KEEBOX Wireless 11n Router
VCI
Most users will not be required to change this setting. The Virtual Channel Identifier (VCI) used in
conjunction with the VPI to identify the data path between your ADSL service provider’s network and your
computer. If you are setting up the Router for multiple virtual connections, you will need to configure the
VPI and VCI as instructed by your ADSL service provider for the additional connections. This setting can
be changed in the WAN Settings window of the web management interface.
VCI
Most users will not be required to change this setting. The Virtual Channel Identifier (VCI) used in
conjunction with the VPI to identify the data path between your ADSL service provider’s network and your
computer. If you are setting up the Router for multiple virtual connections, you will need to configure the
VPI and VCI as instructed by your ADSL service provider for the additional connections. This setting can
be changed in the WAN Settings window of the web management interface.
Information you will need about the Router
Username
This is the Username needed access the Router’s management interface. When you attempt to connect
to the device through a web browser you will be prompted to enter this Username. The default Username
for the Router is “admin.” The user cannot change this.
Password
This is the Password you will be prompted to enter when you access the Router’s management interface.
The default Password is blank The user may change this.
LAN IP addresses for the Router
This is the IP address you will enter into the Address field of your web browser to access the Router’s
configuration graphical user interface (GUI) using a web browser. The default IP address is 192.168.10.1.
This may be changed to suit any IP address scheme the user desires. This address will be the base IP
address used for DHCP service on the LAN when DHCP is enabled.
LAN Subnet Mask for the Router
This is the subnet mask used by the Router, and will be used throughout your LAN. The default subnet
mask is 255.255.255.0. This can be changed later.
Information you will need about your LAN or computer
Ethernet NIC
If your computer has an Ethernet NIC, you can connect the Router to this Ethernet port using an Ethernet
cable. You can also use the Ethernet ports on the Router to connect to other computer or Ethernet
devices.
DHCP Client status
The ADSL Router is configured, by default, to be a DHCP server. This means that it can assign an IP
address, subnet mask, and a default gateway address to computers on your LAN. The default range of IP
addresses the Router will assign are from 192.168.1.2 to 192.168.1.254. Your computer (or computers)
needs to be configured to obtain an IP address automatically (that is, they need to be configured as
DHCP clients.)
It is recommended that your collect and record this information here, or in some other secure place, in
case you have to re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure the Router.
3

Keebox W150NR Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Modulation	16-QAM, 64-QAM, BPSK, CCK, DBPSK, DQPSK, OFDM, QPSK
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Channels quantity	13 channels
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
WLAN data transfer rate (max)	150 Mbit/s
Input current	1 A
Rack mounting	-
Frequency range	2.4 - 2.4835 GHz
Minimum system requirements	- Internet Explorer 6.0, Firefox, Safari, Chrome
WLAN data transfer rates supported	11, 54, 150 Mbit/s
Ethernet LAN (RJ-45) ports	5
Routing protocols	RIP-1, RIP-2
Supported network protocols	PPPoE, PPTP, L2TP
Antennas quantity	1
Antenna gain level (max)	17 dBi
Security algorithms	128-bit WEP, 64-bit WEP, WPA, WPA2-PSK
Certification	- CE, FCC
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 95 %
Product color	White
Cables included	LAN (RJ-45)

Weight and Dimensions

Depth	110 mm
Width	150 mm
Height	25 mm
Weight	200 g