1.7 REPACKING FOR SHIPMENT
The Model 224 should be packed in its original carton. Before
packing, wrap the instrument in plastic. After it is placed in
the box, surround the instrument with Styrofoam packaging
material.
If the Model 224 is to be returned to Keithley Instruments for
calibration or repair include the following:
ATTENTION REPAIR DEPARTMENT on the address label.
Warranty status of the instrument.
Completed service form.
1.6 SPECIFICATIONS
For Model 224 specifications, refer to the specifications that
precede this section.
1.9 ACCESSORIES
The following accessories are available from Keithley In-
struments to enhance the capabilities of the Model 224 Pro-
grammable Current Source.
Model 1019A Universal Rack Mounting Kit-The Model
1019A Universal Rack Mounting Kit can accomodate one or
two Model 224’s. The dimensions are 133mm x 483mm
(5%in. x 19in.I.
Model 1019s is a slide type universal rack mounting kit. The
kit will accomodate up to two half rack size instruments (e.g.
Model 224) in a standard 5%” X 19” rack.
Model 2243 IEEE-488 Interface-The Model 2243 is an op-
tional IEEE-488 interface for the Model 224 Programmable
Current Source. This interface adds extra versatility to the
Model 224 by allowing the transmission of data and com-
mands over IEEE-488 bus. The interface provides all the logic
necessary to interface the Model 224 to the bus using stan-
dard IEEE-488-1978 protocol. Additionally, the Model 2243
incorporates a separate digital I/O port that may be used to
interface the Model 224 to other digital instrumentation.
Model 6011 Triax Input Cable-The Model 6011 is a three
foot (1 meter) low noise triax cable terminated with alligator
clips at one end and a Teflon*
insulated triax connector at
the other end.
Model 6147 Triax to BlilC Adapter-The Model 6147 Triax to
BNC Adapter allows the Model 224 to be used with all
Keithley accessories and cables that require BNC connec-
tions.
Model 6167 Guarded Adapter-The Model 6167 Guarded
Adapter reduces effective cable capacity by driving the inner
shield of a triaxial cable at guard potential.
Model 7008-3 IEEE-488 Cable-The Model 7008-3 is a three
foot (1 meter) IEEE-488 cable. The cable has 24 stranded wire
conductors and is terminated with IEEE-488 standard con-
nectors.
Model 7008-6 IEEE-488 Cable-The Model 7008-6 is a six
foot (2 meter) IEEE-488 cable. The cable has 24 stranded wire
conductors and is terminated with IEEE-488 standard con-
nectors.
Model 7010 Cable Adapter-The Model 7010 is an IEEE-488
cable adapter. The adapter extends the IEEE-488 connector
by one connector width for easy access connections.
Model 7051-2-The Model 7051-2 is a BNC to BNC shielded
cable that is 2 feet long. This cable is especially useful when
utilizing the external input and output trigger connectors.
Model 7051-5-The Model 7051-5 is a BNC to BNC shielded
cable that is 5 feet long. This cable is especially useful when
utilizing the external input and output connectors.
1-2
To Next Page
Loading...
Need help?
General
