In this section:
About this section ................................................................... 10-1
Where can I find updated drivers? ......................................... 10-1
How do I upgrade the firmware? ............................................ 10-2
Why can't the Model 2450 read my USB flash drive? ............ 10-2
How do I change the command set? ...................................... 10-2
Why am I getting a 5074 event code? .................................... 10-3
How do I save the present state of the instrument? ............... 10-4
Why did my settings change? ................................................ 10-4
What are the Quick Setup options? ........................................ 10-5
About this section
This section is helps you find answers to the most common questions encountered with the Model
2450. For additional FAQs, please see the "Frequently Asked Questions (FAQs)" section of the Model
2450 Reference Manual.
Where can I find updated drivers?
For the latest drivers and additional support information, see the Keithley Instruments support
website.
To see what drivers are available for your instrument:
1. Go to the Keithley Instruments support website (http://www.keithley.com/support).
2. Enter the model number of your instrument.
3. Select Software Driver from the list.
You can only use LabVIEW with the Model 2450 SCPI command set.
Section 10
Troubleshooting FAQs
To Next Page
Loading...
Need help?
General
