S530 Diagnostic Manual Appendix C: S530 troubleshooting information
14. After you click Short Check, you will see a dialog box open. Click OK (see next Figure).
Figure 72: Short Check probe connections
In the CVU Confidence Check dialog box, when the test you are performing passes, the button will
turn green and red if it fails.
NOTE
Once you have completed the confidence check tests, you must make sure that all of the relays on
the Model 707B switch matrix are open. Additionally, make sure that you remove the temporary test
cables. If any permanent cables were removed for this testing, make sure that they are reconnected
at this time. Next, close KITE and open KXCI on the Model 4200-SCS and then close your Remote
Desktop Connection.
S530-
906-01 Rev. A / March 2011 4-7
To Next Page
Loading...
Need help?
General
