S530 Diagnostic Manual Section 1: Introduction to S530 Diagnostics
Figure 1: ACS engineer GUI
Operator
Operator mode of the S530 diagnostics is limited in its functionality. Operators are limited to using
diagnostics to load and run diagnostic tests that have been previously created and saved by an
engineer user (see next Figure).
The output of the operator-level diagnostics will display as the testing occurs in the ACS graphical
user interface (GUI), plus a test log and a detailed diagnostic report can be found in the following
default directory after testing is complete:
C:\ACS\Projects\Diagnostic\Reports
S530-906-01 Rev. A / March 2011 1-3
To Next Page
Loading...
Need help?
General
