Keithley S530 User Manual

S530/S540 KTE Linear Parametric Test Library (LPTLib) User's Manual Section 3:
LPTLib command reference
S530-900-01 Rev. E / September 2017 3-3
Matrix commands
Command Description
addcon (on page 3-7)
Add a connection.
clrcon (on page 3-17)
Clear all connections.
conpin (on page 3-21)
Connect a pin or instrument terminal.
conpth (on page 3-22)
Connect path.
delcon (on page 3-25)
Delete connection.
scp_close (on page 3-65)
Disconnect communications to the scope card.
tstsel (on page 3-94)
Select test station.
Range commands
Command Description
lorangeX (on page 3-42)
Define lowest range an instrument should use during
autorange operation (i, v).
rangeX (on page 3-60)
Put a measuring instrument on a specific range (c, i, v).
setauto (on page 3-74)
Re-enable autorange mode.
Source commands
Command Description
forceX (on page 3-29)
limitX (on page 3-41) Limit an instrument to a set voltage or current other than the
instrument default.
pulseX (on page 3-57)
Set the width of a pulse.
Measure commands
Command Description
avgX (on page 3-11) Averages measurements of voltage, current, conductance, or
capacitance.
bmeasX (on page 3-13)
Block measurement; make a series of readings as quickly as
possible.
intgX (on page 3-34)
Integrates a measurement of voltage, current, conductance,
or capacitance.
measX (on page 3-45)
Measure a voltage, current, conductance, or capacitance.
refctrl (on page 3-62)
Enable or disable automatic reference measurements.
setXmtr (on page 3-81)
Set the source to operate as a voltmeter or current meter.
ssmeasX (on page 3-86)
Steady state measurement (i, v).

Keithley S530 Specifications

General

Brand	Keithley
Model	S530
Category	Test Equipment
Language	English