Kenwood 1090VR User Manual

Preparations ¢Turn on the power to the related compo-
nents.
Listening to a source component
Turn on the receiver.
wa
ON/STANDBY
J
“Caton snould be i
3 | Select the source you desire.
INPUT SELECTOR
a (( \\
Start playback from the selected source.
5 Adjust the volume.
VOLUME CONTROL
« (CY)
DOWN uP
Decrease volume
Increase volume
VOSOVR {En/K}
¢ Surround modes cannot be activated when both SPEAKERS A and
SPEAKERS B are set to ON. For details on the SPEAKERS B button,
see “Controlling the sound in another room (ROOM By". 45.
¢ Be sure to set the SPEAKERS A key to the ON position when using the
PRE OUT jacks in Room A. No sound is output from the SUBWOOFER
jack when the SPEAKERS A key is set to the OFF position.
The input sources change as shown below:
1: TUNER (Frequency display)
2 “PHONO"("PHONO"™*)
3 "VIDEO1" ("SAT"*)
4 "VIDEO2" ("LD"*)
5. "VIDEO3" ("VCR"*)
6
7
8
9
‘4
“VIDEO4" ("DSS"*)
“AV AUX”
"CD" ("CD"*)
9 “TAPE1/MD" ("TAPE"*)
* Once setup codes are registered in the remote contra, the input name
display changes according to the name of the registered component,
Example: if you register a VCR at the VIDEO 1 jacks, "VCR1" appears
instead of "VIDEO 1”. : — 38,
¢ Both the default input name and the component type (.e., " VIDEO1
"VCR1'") are shown in the on screen display when the OSD mode is
set to ON. ~ 37.
e When using the remote contro! after initial setup, any inputs that have
not been registered with a setup code are deleted from the cyclic list
(except for the "AV AUX" VIDEO input). — 40,
e The INPUT SELECTOR on the front panel of the receiver always cycies
through ail inputs.
Volume display
es

Kenwood 1090VR Specifications

General

Brand	Kenwood
Model	1090VR
Category	Stereo Receiver
Language	English