Kenwood DNX7200 User Manual

62 DNX7200
Hands Free Unit Control
Setting Up the Hands-Free Phone
The Hands-Free system can be set as follows.
Hands-Free Set Up screen
1 1
2 2
3
4
5
6
1 Sets an automatic response time after call
termination. ( "8")
"Off": This function can not use.
"0-99": Sets to calling ring time (second).
2 Sets a ringing tone output position.
( "Front R")
"Front L": Outputs the tone from the front
left-hand side speaker.
"Front R": Outputs the tone from the front
right-hand side speaker.
"Front All": Outputs the tone from the both
front speakers.
3 Sets the beep of the incoming call. (
"On")
"On": Beep is heard.
"Off": Beep is canceled.
4 Displays the Phone Select screen.
5 Displays the Phone Delete screen.
6 Returns to the Hands-Free Control screen.
⁄
• Either the time interval for automatic answer set on this
unit or the time interval set on the cell-phone, whichever
is shorter, takes effect.
• Select the speaker which is further from the microphone
in order to prevent howling or echoes.
Selecting a Hands-Free Phone
You can choose the Hands-Free phone from the
list.
1 Display the Hands-Free Set Up screen
2 Display the Phone Select list
Phone Select screen
1
2
1 Selects the cell-phone to be used as a
hands-free phone.
2 Returns to the Hands-Free Set Up screen.
3 Select a Hands-Free phone you wish to use

Kenwood DNX7200 Specifications

General

Brand	Kenwood
Model	DNX7200
Category	GPS
Language	English