Kenwood KX-W5040 User Manual

REC
PAUSE
key
REC/ARM
key
[@]
DOLBY NR switch
RELAY REC key
DIRECTION switch
Relay recording
This
function
allows
to
record
sound
continuously
from
deck
A
to
B.
1
Insert
tapes
in
decks
A
and
B.
4
Adjust
the
recording
level.
@ Play the music source.
@
Set
the
record-pause
mode
(deck
A).
7 it
|
Deck
A
|
}
Deck
B
2 Set the recording condition.
@)
Optimize
the
recording
balance
and
recording
level.
@) Select the recording mode.
——
@
Adjust
so
that
the
+
3
dB
segments
of
the
peak
fjevel
meter
lights
Two-side recording ;
DIRECTION
—
One-side
recording
at
times.
(@) Stop playing the music source.
@ Select the Dolby NR mode.
5 Start recording.
DOLBY NR
B_ OFF C
@
Play
the
music
source
from
the
beginning.
@ Press the [@] key (deck A).
3
Set
the
relay
recording
mode.
Lights up.
@
Recording
on
deck
B
starts
immediately
after
recording
on
deck
LAY REC A has completed.
—DUBBING—
ONOR. HIGHO
—ccRAsS—— .
ONOR.
HIGHO
To
cancel
relay
recording:
Press the RELAY REC key again.
Note:
Relay
recording
cannot
be
performed
if
the
DIRECTION
switch
is
set
to
’’
CD
”’.
xx.w5040 (En) 15

Kenwood KX-W5040 Specifications

Audio Specifications

track system	4-track, 2-channel stereo
harmonic distortion	Less than 0.6%
recording system	AC bias (Frequency: 105 kHz)
wow and flutter	0.08% (W.R.M.S.)
frequency response (normal tape)	20 Hz to 15, 000 Hz, +3 dB
frequency response (CrOz tape)	20 Hz to 16, 000 Hz, +3 dB
frequency response (metal tape)	20 Hz to 16, 000 Hz, +3 dB
signal-to-noise ratio (Dolby NR ON)	65 dB (Metal tape)
signal-to-noise ratio (Dolby NR OFF)	57 dB (Metal tape)

Input/Output Specifications

input sensitivity/impedance (B DECK LINE IN)	77.5 mV/50 kΩ
output level/impedance (LINE OUT)	390 mV/3.9 kΩ

Physical Specifications

dimensions (W)	440 mm (17-5/16")
dimensions (H)	129 mm (5-1/16")
dimensions (D)	269 mm (10-9/16")
weight (net)	4.5 kg (9.9 lb)

Power

power consumption	17 W