Kenwood KX-W5040 User Manual

IMPORTANT SAFEGUARDS
A Caution : Read this page carefully to ensure
safe operation.
Please read all of the safety and operating instructions
before operating this unit. For best results, follow all
warnings placed on the unit and adhere to the operat-
ing and use instructions. These safety and operating in-
structions should be retained for future reference.
1. Power sources — The unit should be connected
to a power supply only of the type described in the
operating instructions or as marked on the appliance.
2.Power-cord protection — Power-supply cords
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them, pay particular attention to cords at
plugs, convenience receptacles, and the point where
they exit from the unit.
7.Heat — The unit should be situated away from
heat sources such as radiators, heat registers,
stoves, or other units (including amplifiers) that
produce heat.
. Electric shock — Care should be taken so that ob-
jects do not fall and liquid is not spilled into the en-
closure through openings. If a metal object, such as
a hair pin or a needle, comes into contact with the
Never ‘pull or suratch inside of this unit, a dangerous electric shock may
the cord. result. For families with children, never permit chil-
dren to put anything, especially metal, inside this
unit.
3. Grounding or polarization — The precautions
should be taken so that the grounding or polariza-
tion means of this unit is not defeated.
4. Ventilation — The unit should be situated so that 9.Enclosure removal — Never remove the en-
its location or position does not interfere with its closure. If the internal parts are touched accidentally,
proper ventilation. a serious electric shock might occur.
To maintain good ventilation, do not put records or
a table-cloth on the unit. Place the unit at least
10 cm away from the walls.
Do not use the unit on a bed, sofa, rug or similar
surface that may block the ventilation openings.
10. Magnetic fields — Keep the unit away from
sources of magnetic fields such as TV sets, speaker
systems, radios, motorized toys or magnetized
objects.
5. Water and moisture — The unit should not be
used near water — for example, near a bathtub,
washbowIl, kitchen sink, laundry tub, in a wet base-
ment, or near a swimming pool, etc.
11. Cleaning — Do not use volatile solvents such as
alcohol, paint thinner, gasoline, or benzine, etc. to
clean the cabinet. Use a clean dry cloth.
6. Temperature — The unit may not function pro-
perly if used at extremely low, or freezing tempera-
tures. The ideal ambient temperature is above +5°C
(41°F).
4 kx-wes040 (En)

Kenwood KX-W5040 Specifications

Audio Specifications

track system	4-track, 2-channel stereo
harmonic distortion	Less than 0.6%
recording system	AC bias (Frequency: 105 kHz)
wow and flutter	0.08% (W.R.M.S.)
frequency response (normal tape)	20 Hz to 15, 000 Hz, +3 dB
frequency response (CrOz tape)	20 Hz to 16, 000 Hz, +3 dB
frequency response (metal tape)	20 Hz to 16, 000 Hz, +3 dB
signal-to-noise ratio (Dolby NR ON)	65 dB (Metal tape)
signal-to-noise ratio (Dolby NR OFF)	57 dB (Metal tape)

Input/Output Specifications

input sensitivity/impedance (B DECK LINE IN)	77.5 mV/50 kΩ
output level/impedance (LINE OUT)	390 mV/3.9 kΩ

Physical Specifications

dimensions (W)	440 mm (17-5/16")
dimensions (H)	129 mm (5-1/16")
dimensions (D)	269 mm (10-9/16")
weight (net)	4.5 kg (9.9 lb)

Power

power consumption	17 W