KERN KXS-TM User Manual

KXS_KXG-TM-BA_IA-e-1932 55
13.5 Command Mode
RS 485:
 During input „Id 00“(function RS1 12, see chapter 12.12) the instruction format is
the same as with RS232.
 During input "ID 01-99“ "@ID „must be placed in front of the remote control
command, so that the respective scale reacts to the instruction; e. g. to set the
scale to zero with ID 99 the instruction must be sent to "@99MZ“ followed by the
control characters <CR><LF>.
 If there is an error on entered command, letter “E” will show up + “Unidentified
Command”.
e.g. @99MZZ
The response message is  @99E1MZ.
 RS 485 responses only to machines of identified ID-Code.
13.5.1 Command Format A
Host
Command
Slave
Command
MZ Zeroing
SO
Command mode
MT Taring UA* Switch to the first unit*
MG Display gross weight UB* Switch to the second unit*
MN Indicate net weight UC* Switch to the third unit *
CT Delete tare UD* Switch to the forth unit *
SC Continuous data output UE* Switch to the fifth unit *
SA Automatic data output UF* Switch to the sixth unit *
% Stop continuous data output and start instruction mode.
* depending on model
13.5.2 Command Format B
Host
Command
Slave
Data
RW Send current weight value RH Send gross weight without status
RG Send gross weight RI Send net weight without status
RN Send net weight RJ Hi /Lo/ OK status + display value
without status
RT Send tare weight RK Hi/Lo/ OK status + gross weight
without status
RB Send the display value without
status
RL Rear one/ Lo/ OK status + net
weight without status

KERN KXS-TM Specifications

General

Brand	KERN
Model	KXS-TM
Category	Scales
Language	English