Kobalt SM3017LW User Manual

25
A. Checking Laser Line Alignment
(Fig. 25, 27)
Ɣ 6HWWKHVDZWRDPLWHUDQGEHYHOVHWWLQJ
Ɣ 8VHDFRPELQDWLRQVTXDUHWRPDUNDDQJOH
running across the top and down the front of
a board. This line will serve as the pattern line
(Fig. 27) to adjust the laser. Place the board on
the saw table.
Ɣ &DUHIXOO\ORZHUWKHVDZKHDGGRZQWRDOLJQWKH
saw blade with the pattern line. Position the saw
blade to the right side of the “pattern line” for
the laser line location. Lock board in place with
hold-down clamp.
Ɣ :LWKWKHVDZSOXJJHGLQWXUQRQWKHODVHU
guide. The laser line is parallel to the “pattern
line.”
NOTE: Laser line is calibrated and set up to
project to the left of the blade.
When making laser line adjustments, keep
¿QJHUVDZD\IURPWKH212))WULJJHUVZLWFKWR
prevent accidental starting and possible serious
injury.
Ɣ Slide the cutting head forward enough so that
the laser line is visible on the front of the board.
Ɣ /RRNLQJDWWKHIURQWRIWKHERDUGLIWKHODVHUOLQH
is not parallel to the “pattern line” please follow
the instructions listed below under “Front Line”
paragraph.
Ɣ /RRNLQJDWWKHWRSRIWKHERDUGLIWKHODVHUOLQH
is not parallel to the “pattern line” please follow
the instructions listed below under “Top Line”
paragraph.
WARNING
!
25
Top View
Cutting line
Workpiece
Laser line
Cutting line
Blade
Laser line

Kobalt SM3017LW Specifications

General

Brand	Kobalt
Model	SM3017LW
Category	Saw
Language	English