TP-6774 2/14a 101Section 10 Wiring Diagrams
Section 10 Wiring Diagrams
Accidental starting.
Can cause severe injury or death.
Disconnect the battery cables before
working on the generator set.
Remove the negative (--) lead first
when disconnecting the battery.
Reconnect the negative (--) lead last
when reconnecting the battery.
WARNING
Disabling the generator set. Accidental starting can
cause severe injury or death. Before working on the
generator set or connected equipment, disable the generator
set as follows: (1) Move the generator set master switch to the
OFF position. (2) Disconnect the power to the battery charger.
(3) Remove the battery cables, negative (--) lead first.
Reconnect the negative (--) lead last when reconnecting the
battery. Follow these precautions to prevent starting of the
generator set by an automatic transfer switch, remote
start/stop switch, or engine start command from a remote
computer.
10.1 Wiring Diagram Reference
Hazardous voltage.
Can cause severe injury or death.
Operate the generator set only when
all guards and electrical enclosures
areinplace.
Moving parts.
WARNING
Grounding electrical equipment. Hazardous voltage can
cause severe injury or death. Electrocution is possible
whenever electricity is present. Ensure you comply with all
applicable codes and standards. Electrically ground the
generator set, transfer switch, and related equipment and
electrical circuits. Turn off the main circuit breakers of all
power sources before servicing the equipment. Never contact
electrical leads or appliances when standing in water or on wet
ground because these conditions increase the risk of
electrocution.
Model
Point-to-Point Figure Schematic Figure Accessory Figure
6EKOD/5EFKOD
9EKOZD/7EFKOZD
11EKOZD/9EFKOZD
GM79008-C Figure 10-3 ADV-7995-C Figure 10-4 GM33846-D Figure 10-7
Figure 10-1 Wiring Diagrams for Units without Isolated Ground
Model Point-to-Point Figure Schematic Figure Accessory Figure
6EKOD/5EFKOD
9EKOZD/7EFKOZD
11EKOZD/9EFKOZD
GM79009-E Figure 10-5 ADV-7996-D Figure 10-6 GM33846-D Figure 10-7
Figure 10-2 Wiring Diagrams for Units with Isolated Ground