30 TP-6842 9/21
Figure 22 Network Connection for OnCue
®
Plus
1.10.3 Communications Kit
The optional communications kit is factory installed. The communications kit includes the following items:
Interface board with factory set inputs and outputs
Customer connection terminal blocks
Enclosure intrusion alarm switch
Fuel pressure sensor
Connect the outputs to customer-supplied equipment as shown in the section titled: Communications Kit Output Connections,
or on the wiring diagram.
1.11 Prestart Installation Check
Review the entire installation section. Inspect all wiring and connections to verify that the generator set is ready for operation.
Check all items in the following Prestart Checklist.
Air Cleaner. Check that a clean air cleaner element is installed to prevent unfiltered air from entering the engine. See the
generator set operation manual for instructions.
Air Inlets. Check for clean and unobstructed air inlets.
Battery. Check for tight battery connections. Consult the battery manufacturer’s instructions regarding battery care and
maintenance.
Enclosure. Check that all enclosure panels and internal baffling are in place.
Exhaust System. Check for exhaust leaks and blockages. Check the muffler condition.
Inspect the exhaust system components for cracks, leaks, and corrosion. Check for tight exhaust system connections.
Check for corroded or broken metal parts and replace them as needed.
Check that the exhaust outlet is unobstructed.
Oil Level. Maintain the oil level at or near, not over, the full mark on the dipstick.
Operating Area. Check for obstructions that could block the flow of cooling air. Keep the air intake area clean. Do not leave
rags, tools, or debris on or near the generator set.
To Next Page
Loading...
Need help?
General
