TP-5594 5/95 Operation 2-1
Section 2. Operation
To ensure continued satisfactory operation, check the
following items before each startup.
Prestart Checklist
Oil Level. Must be at or near full mark (not over).
Air Inlets. Must be clear and unobstructed.
Compartment. Interior must be clean. Check the
condition of fuel system, exhaust piping, hoses, and
muffler. Iffuel leaks,fumes,exhaustgases, or electrical
sparks are noted, contact a qualified service technician
before operating generator set.
Air Cleaner. Must be clean and properly installed to
prevent unfiltered air from entering the engine.
Electrical. All connections (including battery) must be
tight.
Fuel Levels. Make surethe fuel tank(s)are full andthe
fuel system primed for operation.
Drive Belt. Check radiatorfan, waterpump andbattery
chargingbelttomakesureitisproperlytensionedandin
good condition.
Coolant Level: If the cooling system is equipped with a
coolant recovery tank, check coolant level (and refill
coolant as necessary) attank. Maintain levelaccording
to markings on the tank. Coolant level should be just
belowthefillerneck[approx.3/4to11/2in.(19.38mm)]
when the engine is cold.
Battery. Check connections and level of battery
electrolyte.
Operating Area. Make sure there are no obstructions
blocking the flow of cooling air. Make sure the area is
clean. Rags, tools, or debrismust not be left on or near
the generator set.
Exhaust System. Exhaust outlet must be clear;
silencer and piping must be tight and in good condition.
Exhaust gas must be vented safely outside.
Exercising the Generator
Run the generator set once a week for one hour (under
load). The operator must be in attendance during this
period. Be sure to make all Prestart Checks before
starting the exercise procedure. Startthe generator set
according to the procedure given for the generator
controller.
To Next Page
Loading...
Need help?
General
