TP-7070 8/20 43Section 2 Operation
2.11.3 HMI Settings
2
1. Touch the Modify button
2. Slide to adjust the screen brightness during normal operation
3. Slide to adjust brightness during standby operation
1
3
Figure 2-43 HMI settings
The sliders on this screen allow adjustment of the
screen brightness during operation and standby. The
two sliders are independent. However, if the brightness
in operation mode is near the brightness in standby
mode, then the setting of the second follows the first, as
shown. Conversely, if the brightness is increased in
standby mode, the brightness during use also
increases.
Title Description and possible settings (or selections)
Standby mode
Time (min)
Delay before activation of screen standby mode: from 10 to 600 minutes
HMI connectivity
HMI type *
Use of HMI connected to the base module: Local, Remote
Mode of operation
Use of HMI for remote mode: Full access, Operation, Visualization
Display blue background of locked
button (selector 0/1)
When the selector is at 1, the HMI is connected using the access code (see
section 9.4 - Identification)
Remote HMI number
Remote HMI number: from 1 to 50 in a complete power plant, but limited to 9
HMIs for a base module
Addressing mode
HMI addressing: System, Customer IP, DHCP
Eth1 IP address
Permanent or temporary identification number for the HMI module connected to
another base or to a network (for example: redundant ring)
Eth1 MAC address
Unique permanent physical identification number, which is stored in the HMI
module
* Several choices available for the parameter
These parameters only appear if Remote has been selected
This parameter only appears if Remote and Display have been selected
To Next Page
Loading...
Need help?
General