46 TP-7091 4/23
4.2 Set the Exerciser
Set the exerciser to automatically run the generator set on the desired day and time every week or every two weeks or every
month. See the generator set Operation Manual for detailed descriptions of the exercise operation.
4.2.1 Setting the Exerciser
When power is applied to the RDC2 controller (when the battery or the utility power for the battery charger is connected), you
will be prompted to set the date and time, and then to set the exerciser.
The first setting will flash. Press the Up and Down arrow buttons to change the setting. Press Select to save the setting and
move on to the next. Repeat until the date, time, and exercise are set and the controller display shows the main menu. See the
generator set Operation Manual for more detailed instructions to set the date and time and set the exerciser.
Press AUTO to place the generator set controller into automatic mode.
Figure 35 Set Time, Date, and Exercise
4.2.2 Loaded Exercise
In order to set a loaded exercise using the RDC2 controller, a Kohler
®
Model RXT transfer switch must be connected. See the
generator set operation manual for instructions to set a loaded exercise.
To set a loaded exercise on a generator set connected to a transfer switch other than a Model RXT, use the transfer switch
controller to set the exercise. Refer to the transfer switch operation manual for instructions.
To Next Page
Loading...
Need help?
General
