Komatsu ecot3 GD655-5 User Manual

.
OPERATION
OPERATION
MOVING MACHINE OFF (FORWARD, REVERSE, SHIFTING GEAR), STOPPING
WARNING
When moving off, check that the area around the machine is safe, and sound the horn before moving.
Clear all personnel from the machine and the area.
Use extreme care when reversing the machine. Note there is a blind spot behind the machine.
When brake oil pressure alarm buzzer sounds due to lowering of brake oil pressure, do not operate the machine and wait with
engine idle (low engine speed with no load) until brake oil pressure alarm buzzer stops.
Before starting operations, check that the seat belt is properly installed.
NOTICE
Before starting the machine off, check that the brake oil pressure warning buzzer is not sounding.
CAUTION
Don't shift the gear while depressing the inching pedal.
2 or more second after shifting gear, depress the inching pedal from pressed position.
PREPARATIONS FOR MOVING OFF
WHEN SELECTING MANUAL MODE
1. Set the blade to the travel posture.
For traveling postures of the machine, see "TRAVELING
POSTURE FOR MACHINE (PAGE 3-107)".
2.
Depress the brake pedal (1), depress the inching pedal (2),
and then set gear shift lever (3) to the 1st or 2nd speed.
NOTICE
On slope, do not start the machine at higher gear speeds (3rd or higher).
Be sure to start at the 1st or 2nd gear speed on slope.
3.
Always check that parking brake lamp (5) has gone out.
3 - 108

Komatsu ecot3 GD655-5 Specifications

General

Brand	Komatsu
Model	ecot3 GD655-5
Category	Construction Equipment
Language	English