STORAGE POSTURE WHEN LEAVING MACHINE
NOTICE
When leaving the operator's compartment, set the machine
in the posture shown in the figure for reasons of safety.
1. When leaving the machine for a long time see "LONG
TERM STORAGE" for instructions on correct preparation
of machine for long term storage.
2. When leaving the machine for a short time.
INSPECTION AND MAINTENANCE
To use the machine safely, and to prevent failures before they occur, always carry out checks before starting
and periodic maintenance.
The locations for periodic inspection are as shown in the diagram below.
A
Cracks at end of weld (checks before starting).
2-PIECE BOOM ATTACHMENTS AND OPTIONS
6-16
To Next Page
Loading...
Need help?
General
