3-28
24.2 WHEN REQUIRED
24.2.1 REPLACE AIR CLEANER ELEMENT
WARNING
‡ Never clean or replace the air cleaner element with the engine
running.
‡ When using pressure air to clean the element wear safety
glasses or goggles to protect the eyes.
1. Loosen clip 1 and remove dust cup 2.
2. Loosen wing nut 3 and take out the element.
3. Blow with dry compressed air (max. 0.7 MPa (7 kgf/cm
2
)) to clean
the inside of the case and the dust cup.
(1) Install a cover to the air intake after removing the element.
(2) When installing the element, be sure to assemble the seal
washer.
(3) When installing the dust cup, install with the arrow mark on
the dust cup pointing up.
(4) Replace the element if it has been cleaned six times or used
for one year.
(5) Never remove the air cleaner element when the engine is
running.
(6) If seal washer 4 is damaged or the thread of wing nut 3 is
damaged, replace with new parts.
4. After cleaning, assemble the new element and install the dust
cup.
24. SERVICE PROCEDURE 24. SERVICE PROCEDURE
To Next Page
Loading...
Need help?
General
