2-38
12. OPERATION 12. OPERATION
12.8 OPERATION OF WORK EQUIPMENT
Work equipment control lever 1 can be used to operate the lift
arm and bucket as follows.
LIFT ARM OPERATION
1 Raise ( J )
2 Hold ( N ): The lift arm is kept in the same position.
3 Lower ( M )
4 Float ( * ): The lift arm moves freely under external force.
NOTICE
Do not use the FLOAT position when lowering the bucket.
BUCKET OPERATION
A Tilt ( U )
B Dump ( & )
When the bucket has been operated to the DUMP position, if the
control lever is pulled to the TILT position, it will be held at that
position and the bucket will continue to move.
When the bucket reaches the position set by the bucket positioner,
the control lever is automatically returned to the HOLD position and
the bucket movement stops.
If the lift arm is lowered in this condition, the bucket will contact
the ground horizontally. If the bucket is not horizontal, adjust again.
For details, see “12.11 ADJUSTING WORK EQUIPMENT POSTURE”.
AE061360
Tilt
Dump
To Next Page
Loading...
Need help?
General
