2-28
12.1.4 OPERATIONS AND CHECKS BEFORE STARTING
ENGINE
WARNING
If the control levers are touched by accident, the work equip-
ment may move suddenly. When leaving the operator's com-
partment, always set the safety lock securely to the LOCK
position.
1. Check that parking brake pedal 1 is at the LOCK position.
2. Check that directional lever 2 is at the N position, and that it is
locked by safety lock 3.
When starting the engine, if directional lever 2 is not at the N
position, the engine will not start.
3. Lower the bucket to the ground, then check that work equipment
control lever 4 is locked by safety lock 5.
4. Insert the key in starting switch 6, turn the key to the ON
position, and check that the pilot lamp lights up.
12. OPERATION 12. OPERATION
AM090710
HEAT
OFF
ON
START
To Next Page
Loading...
Need help?
General
