2-40
12. OPERATION 12. OPERATION
‡ When digging and loading on level ground, set the bucket edge
facing down slightly as follows and drive the machine forward.
Always be careful not to load the bucket on one side and cause
an unbalanced load.
A suitable depth for each digging pass is 5 – 10 cm (2 – 4 in).
1. Set the edge of the bucket facing slightly down.
2. Drive the machine forward and operate the work equipment
control lever forward to cut a thin layer of the surface each time
when excavating the soil.
3. Operate the work equipment control lever slightly up and down
to reduce the resistance when driving the machine forward.
When digging with the bucket, avoid imposing the digging force
onto only one side of the bucket.
To Next Page
Loading...
Need help?
General
