KSB BoosterControl Advanced User Manual

8 Commissioning/Start-up/Shutdown
41 of 88
BoosterControl Advanced
8.4.4 Control with one frequency inverter per pump (sequential starting/stopping of
pumps)
Q
H
S
100%
Q
H
S
50Hz
0...50Hz
0...50Hz
0...50Hz
200%
Q
H
S
50Hz 50Hz
300%
Fig.10: Control with one frequency inverter per pump
H Head
Q Flow rate
S Setpoint
Parameter settings can only be made at the service or factory access level.
ü The system is operational.
ü BoosterControl Advanced has been connected correctly.
ü Date and time have been set. (ðSection8.3.2,Page34)
1. Log in to BoosterControl Advanced at service or factory access level.
(ðSection6.6,Page31)
2. Set the parameters for the suction side. (ðSection8.5.1,Page45)
3. Set the frequency inverter parameters. (ðSection8.4.6,Page44)
4. Note dry running protection settings. (ðSection8.5.1,Page45)
5. Set the following parameters:
Table32: Parameter settings for control with several frequency inverters
Parameter Description Possible values
3-2-2-6 Operating mode Motor-mounted frequency inverter,
Hyamat VP
Control cabinet-mounted frequency
inverter, Hya-Eco VP
3-3-1 Number of pumps connected
BoosterControl Advanced reboots; observe notes
1 ... 6
3-4-2-3 Number of pumps started up in the event of a sensor
failure on the discharge side
1 ... 6

KSB BoosterControl Advanced Specifications

General

Brand	KSB
Model	BoosterControl Advanced
Category	Controller
Language	English