15 ELECTRICAL SYSTEM 102
B01562-10
Main work
– Turn protection cap 1 together with the underlying bulb socket counterclockwise
all the way and remove it.
– Pull lamp socket 2 of the parking light out of the reflector.
B01563-10
– Pull out headlight bulb 3.
– Insert the new headlight bulb.
Headlight (HS1 / socket BX43t) ( p. 128)
– Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
Info
Ensure that the O-ring 4 is seated properly.
– Insert the lamp socket of the parking light into the reflector.
Finishing work
– Refit the headlight mask with the headlight. ( p. 101)
– Check the headlight setting. ( p. 103)
15.8 Changing the turn signal bulb (All EXC models)
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
101722-10
Main work
– Remove the screw on the rear of the turn signal housing.
– Carefully remove turn signal glass 1.
– Lightly squeeze orange cap 2 in the area of the holding lugs and take it off.
– Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
– Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W / socket BA15s) ( p. 128)
– Mount the orange cap.
– Position the turn signal glass.
– Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
– Check that the turn signal system is functioning properly.
To Next Page
Loading...
Need help?
General
