SERVICE SCHEDULE 24
8.2Important maintenance work to be carried out by an authorized KTM workshop (as additional order)
S10A S20N S20A S30A S40A S80A J1A
Check/set the carburetor components. x
•
Check the intake diaphragm. x
• • •
Check the clutch lining discs. x
• • •
Check the length of the clutch springs. x
• • •
Check the cylinder and piston. x
• • •
Check the seating of the piston pin. x
• • •
Check exhaust control for functioning and smooth operation,
clean. x
• • •
Change the crankshaft main bearing. x
•
Change the conrod bearing. x
• •
Fully check the transmission. x
• •
Check the shift mechanism. x
• •
Conduct a major fork service. x
•
Conduct a minor fork service. x
• • • • •
Perform a shock absorber service. x
• • •
Grease the steering head bearing. x ( p. 37)
•
Change the foot brake cylinder seals. x
• •
Change the glass fiber yarn filling of the main silencer. x
( p. 61)
• • •
Change the hydraulic clutch fluid. x ( p. 65)
•
Change the front brake fluid. •
Change the rear brake fluid. •
Treat electric contacts with contact spray. •
S10A: Every 10 service hours - corresponds to about 70 liters of fuel (18.5 US gal)
S20N: Once after 20 service hours - corresponds to about 140 liters of fuel (37 US gal)
S20A: Every 20 service hours - corresponds to about 140 liters of fuel (37 US gal)
S30A: Every 30 service hours - corresponds to about 210 liters of fuel (55.5 US gal)
S40A: Every 40 service hours - corresponds to about 280 liters of fuel (74 US gal)
S80A: Every 80 service hours - corresponds to about 560 liters of fuel (148 US gal)
J1A: annually
8.3Important checks and maintenance work to be carried out by the rider
NB1A
Check the gear oil level. ( p. 68) •
Check the front brake fluid level. ( p. 43) •
Check the rear brake fluid level. ( p. 47) •
Check the front brake linings. ( p. 44) •
Check the rear brake linings. ( p. 48) •
Check and adjust the cables. •
Bleed the fork legs. ( p. 32) •
Clean the dust boots of the fork legs. ( p. 32) •
Clean the chain. ( p. 39) •
Check the chain tension. ( p. 40) •
Check chain wear. ( p. 40) •
Check the rear sprocket/engine sprocket for wear. ( p. 40) •
Clean the air filter. x ( p. 63)
•
Check the tire air pressure. ( p. 54) •
Check the tire condition. ( p. 53) •