MAINTENANCE WORK ON CHASSIS AND ENGINE 37
B00019-11
– Mount and tighten screw .
Guideline
Screw, top steering stem M8 17 Nm
(12.5 lbf ft)
Loctite
®
243™
– Check that the wiring harness, throttle cables and brake and clutch lines can move
freely and are routed correctly.
– Check the play of the steering head bearing. ( p. 33)
9.30Greasing the steering head bearing x
800010-10
–
Remove the lower triple clamp. x ( p. 36)
–
Install the lower triple clamp. x ( p. 36)
9.31Removing the front fender
500092-10
– Remove screws . Remove the front fender.
– Make sure the spacers remain in place.
9.32Installing the front fender
500092-10
– Ensure that the spacers are mounted in the fender.
– Position the front fender. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Info
Make sure the holding lugs engage in the start number plate.
9.33Removing the start number plate
500123-10
– Remove screw and take off the clamp.
– Remove screw . Take off the start number plate.
To Next Page
Loading...
Need help?
General
