KTM 250 SX 2010 User Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE 47
–
Adjust the basic position of the foot brake lever. x ( p. 47)
– Attach spring .
9.56Adjusting the basic position of the foot brake lever x
Warning
Danger of accidents Brake system failure.
– If there is no free travel on the foot brake pedal, pressure builds up on the rear brake circuit. The rear brake can fail due to
overheating. Adjust free travel on foot brake pedal according to specifications.
B00008-10
– Disconnect spring .
– Loosen nut  and, with push rod , turn it back until you have maximum free
travel.
– To adjust the basic position of the foot brake lever individually, loosen nut  and
turn screw  accordingly.
Info
The range of adjustment is limited.
– Turn push rod  accordingly until you have free travel . If necessary, adjust the
basic position of the foot brake lever.
Guideline
Free play of foot brake lever 3… 5 mm (0.12… 0.2 in)
– Hold screw  and tighten nut .
Guideline
Remaining screws, chassis M8 25 Nm
(18.4 lbf ft)
– Hold push rod  and tighten nut .
Guideline
Remaining nuts, chassis M6 15 Nm
(11.1 lbf ft)
– Attach spring .
9.57Checking the rear brake fluid level
Warning
Danger of accidents Failure of the brake system.
– If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
– Change the brake fluid of the front and rear brakes according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
400234-10
– Stand the vehicle upright.
– Check the brake fluid level in the viewer .
» If an air bubble is visible in viewer :
–
Add rear brake fluid. x ( p. 48)

KTM 250 SX 2010 Specifications

General

Brand	KTM
Model	250 SX 2010
Category	Motorcycle
Language	English