BRAKE SYSTEM 13
99
13.1 Checking the free travel of the hand brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the hand brake lever, pressure builds up on the front brake circuit.
– Set the free travel on the hand brake lever in accordance with the specification.
E00844-11
(All EXC models)
– Push the hand brake lever to the handlebar and check free
travel
A
.
Free travel of hand brake
lever
≥ 3 mm (≥ 0.12 in)
» If the free travel does not match the specification:
– Adjust the free travel of the hand brake lever.
( p. 99)
E00844-10
(All XC‑W models)
– Push the hand brake lever forward and check free
travel
A
.
Free travel of hand brake
lever
≥ 3 mm (≥ 0.12 in)
» If the free travel does not match the specification:
– Adjust the basic position of the hand brake lever.
( p. 100)
13.2 Adjusting free travel of hand brake lever (All EXC models)
E00844-12
– Check the free travel of the hand brake lever. ( p. 99)
– Adjust the free travel of the hand brake lever with the adjust-
ment screw
1
.
Info
Turn the adjusting screw clockwise to reduce free
travel. The pressure point moves away from the
handlebar.
Turn the adjusting screw counterclockwise to increase
free travel. The pressure point moves towards the han-
dlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not
apply any force.
Do not make any adjustments while riding!
To Next Page
Loading...
Need help?
General
