EasyManuals Logo

KTM 450 SX-F 2019 User Manual

KTM 450 SX-F 2019
163 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
3 IMPORTANT NOTES
10
3.1 Manufacturer and implied warranty
The work specified in the service schedule may only be performed in an authorized KTM workshop and must be
recorded in both the Service & Warranty Booklet and in the KTM Dealer.net, otherwise any warranty coverage will
become void. Damage or secondary damage caused by tampering with and/or conversions on the vehicle is not
covered by the manufacturer warranty.
Additional information on the manufacturer or manufacturer warranty and the procedures involved can be found
in the Service & Warranty Booklet.
3.2 Fuel, auxiliary substances
Note
Environmental hazard Improper handling of fuel is a danger to the environment.
– Do not allow fuel to enter the groundwater, the soil, or the sewage system.
Use fuels and auxiliary substances in accordance with the Owner's Manual and specification.
3.3 Spare parts, accessories
For your own safety, only use spare parts and accessory products that are approved and/or recommended by KTM
and have them installed by an authorized KTM workshop. KTM accepts no liability for other products and any
resulting damage or loss.
Certain spare parts and accessory products are specified in parentheses in the descriptions. Your authorized KTM
dealer will be glad to advise you.
The current KTM PowerParts for your vehicle can be found on the KTM website.
International KTM Website: http://www.ktm.com
3.4 Service
A prerequisite for perfect operation and prevention of premature wear is that the service, care, and tuning work
on the engine and chassis is properly carried out as described in the Owner's Manual. Incorrect adjustment and
tuning of the engine and chassis can lead to damage and breakage of components.
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can lead to consid-
erably more rapid wear of components such as the drive train, brake system, or suspension components. For this
reason, it may be necessary to inspect or replace parts before the next scheduled service.
It is imperative that you adhere to the stipulated run-in times and service intervals. If you observe these exactly,
you will ensure a much longer service life for your motorcycle.
3.5 Figures
The figures contained in the manual may depict special equipment.
In the interest of clarity, some components may be shown disassembled or may not be shown at all. It is not
always necessary to disassemble the component to perform the activity in question. Please follow the instructions
in the text.
3.6 Customer service
Your authorized KTM dealer will be happy to answer any questions you may have on your vehicle and KTM.

Table of Contents

Other manuals for KTM 450 SX-F 2019

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM 450 SX-F 2019 and is the answer not in the manual?

KTM 450 SX-F 2019 Specifications

General IconGeneral
Engine TypeSingle cylinder, 4-stroke
Displacement449.9 cc
Bore x Stroke95 mm x 63.4 mm
StarterElectric starter
Transmission5-speed
Fuel SystemKeihin EFI, 44 mm throttle body
CoolingLiquid cooled
Ground Clearance370 mm
Compression Ratio12.75:1
IgnitionKeihin EMS
Rear SuspensionWP Shock with Linkage
Front BrakeSingle Disc
Rear BrakeSingle Disc
Fuel Tank Capacity7 liters
Seat Height950 mm
Final DriveChain
Front Brake CaliperBrembo

Related product manuals