MAINTENANCE ON CHASSIS AND ENGINE 115
100061-10
– Disconnect spring .
– Loosen nut and with push rod , turn it back until you have maximum free play.
– To adjust the basic position of the footbrake lever individually, loosen nut and turn
screw accordingly.
Info
The range of adjustment is limited.
– Turn push rod accordingly until you have free play . If necessary, adjust the basic
position of the footbrake lever.
Guideline
Free play at foot brake lever 3… 5 mm (0.12… 0.2 in)
– Hold screw and tighten nut .
Guideline
Remaining nuts, chassis M8 30 Nm
(22.1 lbf ft)
– Hold push rod and tighten nut .
Guideline
Remaining nuts, chassis M6 15 Nm
(11.1 lbf ft)
– Reconnect spring .
9.44Checking rear brake fluid level
Warning
Danger of accidents Brake system failure.
– If the brake fluid level falls below the bottom of the viewer, this indicates a leakage in the brake system or worn-out brake lin-
ings. Have the brake system checked in an authorized KTM workshop, and do not ride any further.
To Next Page
Loading...
Need help?
General
