ELECTRICAL SYSTEM 15
165
K00439-11
– Position the headlight mask.
–
Mount and tighten screws
2
.
Guideline
Screw, headlight EJOT 2 Nm (1.5 lbf ft)
–
Mount and tighten screws
3
.
Guideline
Remaining screws,
chassis
M5 5 Nm (3.7 lbf ft)
– Check that the lighting is functioning properly.
Finishing work
– Check the headlight setting. ( p. 170)
15.9 Changing the headlight bulb
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
– Clean and degrease the bulbs before mounting.
– Do not touch the bulbs with your bare hands.
Preparatory work
– Remove the headlight mask with the headlight. ( p. 163)
To Next Page
Loading...
Need help?
General
